Discovery II 4.0 valve sleeves? Off not sure
Camel Trophy
Joined: Oct 2016
Posts: 4,867
Likes: 1,410
From: Michigan
The last picture has those weird marks, can't figure out why or what would have caused that (unless something got in there). But, it's almost like they had a bad day at the machine shop while working on these heads originally.
Can't imagine a shop wanting to mess with them now...especially at the tolerances mentioned above.
Good luck.
Brian.
Can't imagine a shop wanting to mess with them now...especially at the tolerances mentioned above.
Good luck.
Brian.
Thread Starter
|
4wd Low
Joined: Jun 2015
Posts: 10
Likes: 0
The last picture has those weird marks, can't figure out why or what would have caused that (unless something got in there). But, it's almost like they had a bad day at the machine shop while working on these heads originally.
Can't imagine a shop wanting to mess with them now...especially at the tolerances mentioned above.
Good luck.
Brian.
Can't imagine a shop wanting to mess with them now...especially at the tolerances mentioned above.
Good luck.
Brian.
Thread
Thread Starter
Forum
Replies
Last Post
austinlandroverbill
Discovery II
13
Jul 5, 2017 11:11 AM
aussiestuckintexas
New Member Introduction
0
Nov 2, 2014 02:04 AM