Hello,
I’m trouble shooting a knock sensor bank 1 code p100 (210) -read off of a zues code reader @ shop- I came across a double zip tied sensor and a taped wire. My plan is to simply replace the sensor and the wire harness that runs to both knock sensors.

I Cannot Find The Harness. The wire disappears into the engine somewhere. Anyone replace the whole wire assembly before and or have a part number?

I’ve got the rave, and DS2 98-04 parts & accessories off Rimmer Bros -really nice if you don’t have it I’ll attach a pdf.

Thanks.

The wire on the LH side runs along with the Fuel Injector wires under the Upper Intake, comes out behind the A/C compressor, then goes down below the A/C/PAS Bracket under the Knock sensor heat shield(under the exhaust manifold).

The wire on the harness is an internal wire with the ground wire wrapped around it, so it looks like a single wire, I am sure there is a name for that, but I do not know it, difficult to work wifh, but I recently did mine so it is possible.

Ya I’m looking to replace the harness, thanks for laying out where it is.

Anyone have a part number?