Okay so I have ben at it for hours. I took all the actuators out and tested them, they all work 100 percent. I believe that i some how enabled single point entry on this damn thing. It is all that makes sense. When I reinstall the actuators in the Disco I can hear the passenger and both rear doors try to unlock/lock but they do not. The BCU is is locked in this single point entry mode and I have no clue how I put it in that mode. Maybe it was a night I had way to many martinis. Does anyone know how to disengage the single point entry?

 

Are you superlocked? Inertia switch reset?

Single Point Entry on/off is a program command for the BCU

Flash for odometer error on/off is also a program command for the BCU

Perhaps you have somehow scrambled program in BDU, time for dealer?

 

Savannah all the actuators work but only drivers side opens with remote. Its not super locked. I did reset what I believe was the inertia switch and still nothing. I really don't want to go and get ripped off by the dealer. Do you know of any way to reset the bcu?

 

I think you covered this, but it is once for driver's door and then press again for all. I have to do it with maybe a one second pause in between. Pressing it twice quick doesn't work, and too long of a pause doesn't work.
When you press the unlock button inside, all doors unlock, correct? It sounds like something funny is going on with the BCU for sure considering this all started when unplugged.