Relocated coil packs (with pics!)
#22
There was lots of room with the top end off. No problem, took about 20 minutes to cut, solder, and heat shrink. I always use heat shrink on Individual wires and then use a heat shrink sleeve over the connections that has an apoxy inside that melts and then seals the whole think up when it's cool
Last edited by KingKoopa; 01-13-2017 at 11:52 PM.
#23
#24
I doubt I would have bothered with it if I hadn't had the heads off, but I'm def glad I did. My plan for the vehicle is reliability and ease of maintenence on the road and on the trail. As time goes on I would like to simplify/delete/modify any piece of convoluted British engineering that is unreliable or unfixable on the trail. It's a tall order but I think it's possible.
The following users liked this post:
conrad1468 (01-18-2017)
Thread
Thread Starter
Forum
Replies
Last Post
meltdowndave
Discovery II
2
12-29-2009 01:54 PM