Storm messed up my D2
Thread Starter
|
Winching
Joined: Dec 2008
Posts: 669
Likes: 9
From:
Storm messed up my D2
First, my thoughts and prayers to the people of Glade Spring, VA. Was on my way home today and went thru there and can't believe the damage I saw.
I got home to find only minor damage to the front of my house. Neighbors said we had 70 mph wind and golf ball sized hail. My D2 has the left outside mirror broken, both tail-lights cracked, and a few dents on the hood. Amazing the sunroof wasn't shattered. Anyhow, I started it up and noticed that the radio didn't work and the check engine light was on. Checked the fuse for the radio and it's good and there's power to the radio so I guess it got cooked. Tried to read the codes and my scanner said it was not connected. I tried my other scanner and got the same thing... not connected. I drove all over town and it runs great... cruise and a/c work fine. I don't think it could be anything too serious as I doubt it would even run if the ECM got cooked.
Eric
I got home to find only minor damage to the front of my house. Neighbors said we had 70 mph wind and golf ball sized hail. My D2 has the left outside mirror broken, both tail-lights cracked, and a few dents on the hood. Amazing the sunroof wasn't shattered. Anyhow, I started it up and noticed that the radio didn't work and the check engine light was on. Checked the fuse for the radio and it's good and there's power to the radio so I guess it got cooked. Tried to read the codes and my scanner said it was not connected. I tried my other scanner and got the same thing... not connected. I drove all over town and it runs great... cruise and a/c work fine. I don't think it could be anything too serious as I doubt it would even run if the ECM got cooked.
Eric
Thread Starter
|
Winching
Joined: Dec 2008
Posts: 669
Likes: 9
From:
I was in Charleston, SC. I wasn't here for the storm but my neighbors told me about it and I saw the damage to their vehicles and think my Disco did quite well. I tried my scanner again today and now its able to read the codes 
Don't know why it wouldn't do that yesterday but all it showed was P0440. (EEC System Malfunction) I usually get P0445 but only when I'm below 1/2 tank. (which to me is like an early low fuel light 
) Never saw that before. So I erased it and did some driving around and it hasn't come back. One other thing has started happening.... every time I start it up, the alarm goes off while I'm cranking it and once it's running, the alarm shuts off. But it always starts and runs. I almost never lock it so don't know why it's doing that. May have to make a trip to the dealer to make sure my BCM isn't about to die. They only charges $50 to reprogram my SLABS last year so they'll probably only charge that to run a diagnostic on the BCM. Think I'll park it for now... I would hate to have it go into lock-down mode somewhere and have it towed.
Eric
Don't know why it wouldn't do that yesterday but all it showed was P0440. (EEC System Malfunction) I usually get P0445 but only when I'm below 1/2 tank. (which to me is like an early low fuel light ) Never saw that before. So I erased it and did some driving around and it hasn't come back. One other thing has started happening.... every time I start it up, the alarm goes off while I'm cranking it and once it's running, the alarm shuts off. But it always starts and runs. I almost never lock it so don't know why it's doing that. May have to make a trip to the dealer to make sure my BCM isn't about to die. They only charges $50 to reprogram my SLABS last year so they'll probably only charge that to run a diagnostic on the BCM. Think I'll park it for now... I would hate to have it go into lock-down mode somewhere and have it towed.Eric
Thread
Thread Starter
Forum
Replies
Last Post
knac1234
Discovery II
1
Jun 3, 2009 07:51 PM
cellman01
General Range Rover Discussion - Archived
6
May 8, 2008 07:08 AM
