What should my oil pressure be?
#12
#13
Alright guys, I’m officially an idiot. I went back through Auber’s website and found instructions for my transducer, which required different inputs than their standard setup instructions.
The truck is already warm but right now it’s bouncing between 19-20 at idle and 43-45 at 2k RPM.
Thanks everybody for the discussion and getting me concerned enough to dig deeper.
The truck is already warm but right now it’s bouncing between 19-20 at idle and 43-45 at 2k RPM.
Thanks everybody for the discussion and getting me concerned enough to dig deeper.
#14
#15
Ill post some pics in a few minutes of the gauge and adapter.
#16
Sorry that took a while.
Heres the adapter, it is the 3/4 UNF - 16 version. I got it from Amazon. It’s sort of hard to see, but the silver things are plugs, then you can see the transducer with wiring coming off as well.
And then here’s my gauge. I took out the whole piece that houses the coin slot, ash tray and drink holders. I plan to dremel off the center part and put the ash tray and coin slot thing back in eventually. Wiring is run behind where the coin slot would be, through an opening into where the fuse panel is, then through the main gromet in the firewall by the pedals.
I’ll probably add more at a later time once I figure out what I want to monitor.
Heres the adapter, it is the 3/4 UNF - 16 version. I got it from Amazon. It’s sort of hard to see, but the silver things are plugs, then you can see the transducer with wiring coming off as well.
And then here’s my gauge. I took out the whole piece that houses the coin slot, ash tray and drink holders. I plan to dremel off the center part and put the ash tray and coin slot thing back in eventually. Wiring is run behind where the coin slot would be, through an opening into where the fuse panel is, then through the main gromet in the firewall by the pedals.
I’ll probably add more at a later time once I figure out what I want to monitor.
The following 2 users liked this post by attworth:
longtallsally (09-07-2018),
Richard Gallant (09-07-2018)
#18
#19
#20
Thread
Thread Starter
Forum
Replies
Last Post