P0151-1A & P0051-00 o2 Sensor Bank2, Sensor 1
#11
That particular O2 is not easy to get it. But you can sorta do it from above. Normal protocol is to disconnect the shaft. I did so and still did not have enough room. With some extensions, a short ratchet and a crows foot - one can use a few combinations and get to it from above. The hardest part is laying on the engine or over the fender in some way to see back there.
#12
Just to close this one ... it was in fact the o2 Sensor on the Drivers (Right) side before the CAT and above the driveshaft ... i tried to get to the darn thing more then a few times but ultimately had to break down and have the shop replace it for me :-)
Thanks for the direction and confirmation of Banks Abran !!
Thanks for the direction and confirmation of Banks Abran !!
I am able to get the driver front O2 sensor without removing the driveshaft from the bottom and I have fat arms and hands. Just an FYI, it's possible.
#13
Thread
Thread Starter
Forum
Replies
Last Post
*RANGER*
General Range Rover Discussion - Archived
3
03-12-2008 05:17 PM