Engine knock
#1
Engine knock
Since there is an engine knock thread going, I thought I would share.
Ive had 2 engines cone in with holes in them. One had a hole in the pan and would not start, the other had what the owner said started as a mild knock from low oil which turned into a major knock. It was still running before o broke it down, although loud and rough.
The first I elected to scrap without breaking down. The second I broke down and found a hole in the side of the block once I removed the motor mount bracket. 2 broken rods, one piston had been hammered by the valves.
Ive had 2 engines cone in with holes in them. One had a hole in the pan and would not start, the other had what the owner said started as a mild knock from low oil which turned into a major knock. It was still running before o broke it down, although loud and rough.
The first I elected to scrap without breaking down. The second I broke down and found a hole in the side of the block once I removed the motor mount bracket. 2 broken rods, one piston had been hammered by the valves.
The following users liked this post:
djkronik57 (02-12-2017)
#2
Thread
Thread Starter
Forum
Replies
Last Post