So what did you do to your Disco today?
#2601
#2606
I'm converting my AC compressor into On Board Air.
I had the AC Compressor and hoses from my parts truck so I cut off the fittings.
I cut the remaining portion of the hard lines off the fittings today. Tomorrow I'll drill and tap them for 1/4" NPT. My plan is very similar to Darkstar's first build.
One thing I needed to deal with was a tank of some sort for my Ashcroft lockers. I really didn't want a large tank because I would have to mount it either under the truck or in the cargo area and both were not ideal. I figured lots of guys run their air lockers off those tiny ARB pumps with tiny tanks so I set off to find a small tank.
Came across this on EBay. It's approximately 1/4 gallon. And it came with a regulator/filter and pressure switch.
Next step is to order fittings and 3/8" air brake line.
I had the AC Compressor and hoses from my parts truck so I cut off the fittings.
I cut the remaining portion of the hard lines off the fittings today. Tomorrow I'll drill and tap them for 1/4" NPT. My plan is very similar to Darkstar's first build.
One thing I needed to deal with was a tank of some sort for my Ashcroft lockers. I really didn't want a large tank because I would have to mount it either under the truck or in the cargo area and both were not ideal. I figured lots of guys run their air lockers off those tiny ARB pumps with tiny tanks so I set off to find a small tank.
Came across this on EBay. It's approximately 1/4 gallon. And it came with a regulator/filter and pressure switch.
Next step is to order fittings and 3/8" air brake line.
#2607
Join Date: Apr 2010
Location: Upstate South Carolina
Posts: 1,450
Likes: 0
Received 2 Likes
on
2 Posts
Pulled the power steering pump and mounting bracket off my parts truck and am finally getting the ball rolling on the Saginaw P series pump swap. Hopefully I'll get the pully pressed on the saginaw so I can take some measurements for what size spacers I need. Going to drill new holes in the PSC saginaw jeep bracket, weld the spacers the the bracket, weld the engine hook plate on the back side of the spacers and box the open areas between the spacers with plate to add some reinforcement. I'm going to try to take a good bit of pictures so other people can replicate it if they want.