Lift Measurements
#21
#22
#23
Yeah. There rear of mine is certainly over 3 inches from where I started, the front is probably more like 2 or 2 1/2.... but I have a winch and a bull bar up front.
#25
here are my numbers: https://landroverforums.com/forum/di...e-54403/page2/
So according the measurements on my truck, I get 2" in front and 3" in back over stock... which is right in line with a 2" HD lift... because I'm loaded relatively heavy in front... and not at all in the back. Maybe when I get my bumper put on and any other armor I'll be only 2" lift in the back too.
Last edited by jafir; 12-14-2012 at 09:47 PM.
#27
The fronts fit in the dent in the perch, if that's what you are asking, and the rears are using the stock perches, my 03 came with springs cause it's the cheap one. I also used the old, stock, worn-out isolators in the back. Which is dumb, because I had new ones in the coil conversion kit I bought for the 99. If I buy more bling and the rear sags too much, I'll think about D1 perches.... though I won't lie the springs were pretty tight to squeeze in there as it was.
#28
#29
Though according to your signature, you are loaded down quite a bit more than I am, with sliders, roof rack, and an HD rear bumper.
#30