I'm looking for a reasonably priced lower windshield finisher and a left rear bumper trim corner.

Anyone tried 3D printing one? Probably could sell some if you could pull it off.

Brian in San Antonio

 

Used will just crack pretty quick. Get a new one from lucky8 for about 240 bucks

 

isn't there someone in malaysia or the philippines selling fibreglass ones on ebay?

 

Yes but same price as the OEM when you add shipping

 

uh, the point being that the oem ones crack all the time but the fibreglass ones don't. and if they're the same price...

 

i have both A pillar finishers and the cowl from Malaysia. i like the way they look and fit.

i especially like how the windshield cowl doesn't form a crack if i look at it wrong.

 

This is straight from Rexypow’s Malaysian website....
https://www.rexypowparts.com/product...el-cowl-plenum

 

They say on their web page that the "Plenum/air intake area has been sealed" can you explain what they did here. Does the AC still work in both Fresh air and recirculate modes?

Brian

 

it does. i have had the Malaysian cowl for some time and noticed no difference before and after with the AC. still blows cold.

edit: if you're worried about air flow you can always drill a few holes in the sealed area.

 

I have a factory used cowl. No cracks, no missing hooks.