Stumped with hazards flashing, no start

Reply Subscribe

Thread Tools

Search this Thread

Jun 7, 2020 | 08:50 AM

#11

RoverSE7

Mudding

Joined: Jan 2020

Posts: 115

Likes: 11

From: Fishkill, NY

Quote:

Originally Posted by frostythor

yes flashing 4 way light and not starting is the immobilizer circuit, when I had it no matter how many times I reset it did not start, it did after I removed the wire individually and cleaned the all flashing stopped and it started first turn of the key

Hi I have the same issue Flasher on Wont start.... What wire did you unplug? to what device? I just tried swapping out the inertia switch from another LRD2 i have. Still no start Flashers on AND i have these Green geared M & S icons flashing. NO alarm LED or anything... I am stumped

Jun 7, 2020 | 09:18 AM

#12

scostagl

Thread Starter

4wd Low

Joined: Apr 2018

Posts: 11

Likes: 1

Trace the wires from inertia switch to the fuse box. See if you have any frayed or damaged wires. That’s likely the issue if you’ve already tried replacing the switch.

Jun 7, 2020 | 11:10 AM

#13

frostythor

Rock Crawling

Joined: Jan 2020

Posts: 374

Likes: 122

From: NEW FOREST, UK

I pulled the wire off the inertia switch and cleaned them up, luck for me that was all it was, but it only needs one wire in the system to earth and its a no go

Jun 8, 2020 | 05:43 AM

#14

RoverSE7

Mudding

Joined: Jan 2020

Posts: 115

Likes: 11

From: Fishkill, NY

White & Green wire to blame!

I found the issue under the fuse box by advice from another member in another thread. The White & Green wire was corroded right through creating and open circuit to the Inertia switch. Once repaired Bingo! Engine started and flashers went off.
Thanks to all guys & gals on this forum to help each other out. I will do my part as i can. Thanks Again!