What did you do with your DII today?
#3121
Oh btw does anyone knows where i can get a HD version of the roto flex?
#3122
#3124
#3126
#3127
R&R'd X,Y,Z Switch
Installed a used X,Y,Z switch. Simple and straight forward. As others have said no special LR tool required. Prior to tightening the two retaining bolts checked for correct gear selection. Allowable switch movement can allow faulty indication of some positions. Adjusted per common sense and torqued bolts. Ops check good.
No longer need to clear faults & S&M lights via my ScanGauge after each use of reverse gear. Transfer box high/low range selection no longer locked out and diff lock light now off immediately after unlocking rather than having to go into reverse prior to extinguishing.
......
No longer need to clear faults & S&M lights via my ScanGauge after each use of reverse gear. Transfer box high/low range selection no longer locked out and diff lock light now off immediately after unlocking rather than having to go into reverse prior to extinguishing.
......
#3128
Alfred the D2 has been neglected this month as I had to do brakes on she who must be obeyed's LR4, door locks on the Classic and trying to get the 109 registered.
But then this happened...
(edit: fixed link)
I'm about 3 days or so from having this up and running as my daily driver. After that, it's LC9 time for my 2 d2's.
But then this happened...
(edit: fixed link)
I'm about 3 days or so from having this up and running as my daily driver. After that, it's LC9 time for my 2 d2's.
Last edited by Robert Booth; 02-13-2016 at 11:39 AM.
#3129
Trans Fluid/Filter
Finally got around to ZF trans fluid and filter service. Fluid drained was rode hard/put up wet and likely never changed prior. Plan to repeat drain/refill sans filter a couple of times soon for further purge/dilution of old fluid. Used my newish 2 mm bead measuring tool to ensure proper fluid level. Trans seemed fine before but now is noticeably smoother shifting and torque converter lockup occurring at lower MPH/RPM. Dirty work and result's can be rewarding.
......
......
Last edited by number9; 02-13-2016 at 10:54 PM.
#3130
Coil Packs and wires...fun.
First week with the car and already digging in. Two days into cruising my Discovery popped a misfire #5 code. No spark led me to swapping the coil packs. While I was at it I decided to do valve cover gaskets, throttle body service, upper intake gasket, wires and plugs. Took 6 hours but got a lot done and good to go. Was not difficult at all. Toughest part was removing the secondary air.