engine removal
#12
I'm actually in blissful zen mode right now. Motor is on the stand, trans and t case are packed away, I feel great.
Just need to strip the rest of the vehicle and start working on a tranny rebuild on my high mileage 05'.
Looking back it wasn't so bad, just new to me.
Anybody know how to remove the front axles? Maybe that is a new thread...
Just need to strip the rest of the vehicle and start working on a tranny rebuild on my high mileage 05'.
Looking back it wasn't so bad, just new to me.
Anybody know how to remove the front axles? Maybe that is a new thread...
#14
#15
#16
To remove the half shafts, get a 2x4 (or equivalent piece of wood) and place it as best you can to hammer it outward from the diff. Be careful of the sheet metal debris shield right as the half shaft goes into the diff - don't hammer on that. For the driver's side, you are probably going to have to remove the bolted-on cross member that is right under the diff to get a better angle for the 2x4. Then smack the 2x4 with a hammer and drive the half shaft out
The following users liked this post:
abran (08-26-2015)
Thread
Thread Starter
Forum
Replies
Last Post