What did you do with your DII today?
#1791
I used electrical tape to seal up the flexible part of the air intake tube from the air box to fender. I noticed my air intake temps were a little higher then normal on the ultragauge and after looking around I found the intake tube had some holes and was probably sucking in the hot engine compartment air. I deleted my before picture on accident, but the mesh like material was falling apart and had some good size holes in it. I couldn't find a replacement part so I figured I would give electric tape a shot. The tape sealed it up really go and it doesn't look that bad at all. Nice and cheap repair.
Last edited by Jared9220; 05-14-2014 at 06:30 PM.
#1793
Follow the thread on expedition portal for updates, just did the timing belt the other day.
Solving the gas Crisis - 95 Discovery I - Expedition Portal
#1794
I've checked the expo portal build before, didn't get too far into it, but I got far enough ^ . Really though, I only lurk there, not really involved with the forums on expo. Maybe once I start taking pictures/filming my trips after my axle swap I'll post there more often, but I feel like I'll post the actual build thread here, because on this forum its just blown head gaskets and slipped liners, it'd be nice to see a change.
#1795
#1796
Yeah, your right, the D2's have a more off road based crowd (thank god). I just need to actually commit starting the build. I have the axles, which is the biggest part of the build, now I just need... well, a lot of the little things. I'll start my build thread after I actually have everything.
#1797
#1798
#1799
#1800